BQ12 SERIES HYDRAULIC SINGLE-CHUCK VENEER LATHE

Thismachineisoneofthemainmachineinplywoodproductionline.Itisusedtodrytheveneer

This machineis one ofthe main equipmentsin artificial board productionine.lt cancutthe edge crosswise and lengthwiseto getthe artificial board with size needed .

This machine is a main machine in plywood production line，It is used to hot-press combine the mat which after glue-spreading combination.

This pre-compressor is an auxiliary machine in the plywood production line.it can pre-press the glued veneers which are made into mat and make them fall into a pattern.It is an important machine to raise the quality of plywood.

This machine is used to cut the whole veneer and to trim their edges.

This machine is used to roll the veneer made form the wood after being cut and it is matched with common veneer lathe.

This machine has high precision and easy operation characteristic and it can reduce the insecure factor during the productive process.

This machine is drived by DC adjustable apeed motor.Normally it is working with peeling machine.

This equipment is a highly automatic equipment for the spindless veneer lathe and hydraulic double-chuck spindle veneer lathe. It is using numerical control system.

This machine is the necessary equipment for producingknife factory. It is applied to grinding the large size of part and knife. It has high efficiency and precision characteristic.

this machine is mainly used to peel log with small diameter ， the main drive motor is AC motor or DC motor, which can be provided according to users request.

this machine is a high quality, and efficiency veneer lathe for small log peeling.The main driver is advanced numerical controlled DC motor. The operation of the machine is program controlled. It can match with the projection block centering and charging machine and the synchronous reeling machine.

This machine is used for the veneer peeling and shearing of large diameter wood after rounding. The wood core with a diameter of no more than Φ480mm can be peeled into veneers with different thicknesses of 1.0-3.0mm to improve the utilization rate of wood. It adopts advanced servo technology to control, make the cutting precision similar to the card rotary cutting machine, easy to use, can coopera

This machine is the main equipment of the plywood manufacturer. It is used for the peeling of the remaining wood core of the rotary cutting machine with a pinch and the rotary cutting of the veneer after the small diameter wood is rounded. The wood core with a diameter of not more than Φ400mm can be peeled into veneers with different thicknesses of 1.0-3.6mm to improve the utilization rate of wood

This machine is mainly used for the rotary cutting of relatively large wood diameters, and can also be used for the rotary cutting of face plates. It adopts the working principle of the large-diameter wood rotary cutting machine with stuck shaft to make the rotary cutting accuracy more precise. Is the company's patented product, patent number: 4472995